MEP Estimating for Multifamily Projects: What Contractors Need to Know

Apartment buildings are some of the most common projects MEP contractors bid in the United States. They look repetitive, with the same unit plan on every floor, but that repetition can hide expensive mistakes. One missed item in a typical unit is multiplied by every unit in the building. This guide explains how to approach MEP estimating for multifamily projects.

Start with the unit types

Most multifamily buildings have a handful of unit types (studio, one-bedroom, two-bedroom and so on). Take off each unit type once in full detail, then multiply by the unit count from the unit matrix. Check that the matrix on the architectural sheets matches the floor plans, because changes during design often leave them out of sync. Mirrored units use the same quantities but can change pipe and conduit routing to the risers.

Electrical in multifamily buildings

  • Unit load centers, receptacles, switches, lighting, smoke and CO detectors
  • Kitchen and laundry circuits, and HVAC equipment circuits for each unit
  • Meter banks or meter centers, and feeders from the meters to each unit panel
  • House panels for corridors, amenity spaces, parking and site lighting
  • Low voltage: data, TV, intercom or access control, and fire alarm devices
  • EV charging in the parking area, which is now required or requested on many projects

Unit feeders are a frequent source of error. Each unit has its own feeder from the meter bank, so feeder lengths grow floor by floor. Measure them by floor, not with one average length for the whole building. See our electrical estimating services.

Plumbing in multifamily buildings

  • Fixtures for each unit type: water closets, lavatories, tubs or showers, kitchen sinks, dishwashers and washer boxes
  • Water heaters, either one per unit or a central system with recirculation
  • Domestic water, waste and vent risers, with offsets at transfer floors
  • Sleeves, firestopping and acoustic isolation between floors
  • Garage drains, roof drains, storm piping and grease interceptors for amenity kitchens

Count the risers carefully. A stacked layout with clean vertical risers costs much less to install than a layout where pipes must offset at every floor. More on our plumbing estimating services page.

Mechanical and HVAC in multifamily buildings

  • Unit HVAC: split systems, packaged terminal units, fan coils or VRF indoor units
  • Refrigerant piping or hydronic piping to each unit, and condensate drains
  • Bathroom, kitchen and dryer exhaust for every unit, often with roof fans or shafts
  • Corridor pressurization or ventilation, and amenity-space HVAC
  • Garage exhaust, if the building has enclosed parking

Dryer exhaust and bathroom exhaust are easy to undercount because they are small items, but they repeat in every unit. See our mechanical and HVAC estimating services.

Common mistakes on multifamily MEP bids

  • Wrong unit count. Always check the unit matrix against the plans.
  • Forgetting the common areas. Lobbies, corridors, gyms, clubhouses, trash rooms and parking can add a large amount of work.
  • Ignoring the construction type. Wood frame, podium and concrete buildings have very different labor for sleeves, hangers and firestopping.
  • Missing utility and site work. Water and sewer services, transformer pads and site lighting are often in the MEP scope.
  • Not pricing labor for repetition. Crews get faster on typical floors, but the first floors and the roof usually take longer.

Get a multifamily MEP estimate

MEP Estimation Services prepares electrical, plumbing and HVAC takeoffs for apartment and mixed-use projects across the United States, organized by unit type and floor, with marked-up drawings and editable Excel files. Send your plans for a free quote or read what an MEP takeoff includes.