Electrical Load Calculation Services

Before you can price an electrical service, add EV chargers or put a new tenant on an existing panel, you need to know the load. Our electrical load calculation services help electrical contractors, general contractors and developers size services, feeders and panels using the methods in NEC Article 220 (Branch-Circuit, Feeder, and Service Load Calculations), applied to the code edition your jurisdiction has adopted.

Load Calculations We Prepare

  • Service and feeder load calculations for new commercial, multifamily and residential buildings
  • Panel schedules and panel load summaries, with connected and demand loads
  • Existing-service capacity checks before adding tenants, equipment or EV chargers, using either measured demand data or the calculation methods the NEC allows for existing installations
  • EV charger additions, including whether the existing service can support the chargers or needs an upgrade or load management
  • Dwelling unit calculations using the standard or optional methods in Article 220

What a Load Calculation Includes

  • General lighting and receptacle loads based on occupancy and floor area
  • Motor, HVAC and equipment loads from the mechanical and equipment schedules
  • Continuous loads, demand factors and the largest-motor allowance applied per the code
  • Kitchen equipment, water heating, EV charging and other specific appliance loads
  • A summary of total demand load and the resulting service or feeder ampacity

How Load Calculations Support Your Estimate

The service size drives some of the largest costs on an electrical job: switchgear, transformers, utility coordination and feeders. A load calculation done before bidding helps you price the right equipment and avoid paying for an upsized service after award. We can combine the calculation with a full electrical estimate or quantity takeoff for the same project.

Adding chargers to an existing site? See our guide to estimating EV charger installations.

What We Need From You

  • Electrical, mechanical and plumbing drawings, including equipment schedules
  • Building area and occupancy type
  • For existing buildings: the existing service size, panel schedules and, if available, 12 months of utility demand data
  • The NEC edition and any local amendments that apply

Load Calculation FAQs

Are your load calculations stamped by an engineer?

Our load calculations are prepared for estimating, bidding and planning. If your permit or jurisdiction requires calculations sealed by a licensed professional engineer, the engineer of record must review and seal them. Tell us about this requirement when you request a quote.

Which NEC edition do you use?

The edition adopted where your project is located, including local amendments. Adoption varies by state and city, so tell us the location and we will confirm the edition.

How long does a load calculation take?

Most are delivered within 24–48 hours. Large buildings or calculations combined with a full estimate can take longer, and we confirm the delivery date before we start.

Request Your Load Calculation

Upload your drawings on our contact page, email info@mepestimationservices.com or call +1 302-556-0442. Quotes are free.